The light system can be automatically controlled to deliver the right light level at the right time. Work light provides a bright,
full-spectrum light that lets farmers work safely and inspect cows easily. But when they’re on their own, cows don’t need
all that light – they can’t even see a large proportion of it. Herd light delivers only the light that cows need and saves you
paying for the rest.
Features of RTL-BR15H80W :
1. Beam angle: 360° and 180° for option
2. IP69K, IK08, IP66
3. Double function of red light and full-spectrum light for cow vision, which can be switched randomly.
4. Function Selection:
a) Dimming controller: Non-Flicker with dimmable, simulate the setting of sun illumination, sunrise and sunset. Automatic operation 24 hours a day.
b) Nature Light Harvest Sensor:Identify natural light and artificial light, adjust the light LUX to keep the ambient illuminance within the required range.
Reduce power consumption by up to 75%
Studies have shown that milk production increases when cows are exposed to 16 hours of light each day.
But by studying the actual cause of this increase – a reduction in hormone levels – REAPWAY was able
to identify that the same effect could be achieved using a lot less energy, simply by removing the light
that cows can’t see. Cows’ yield still increases due to longer light exposure, but the energy needed to achieve
this can be reduced by up to 75%.
See in the dark
For the remaining 8 hours, cows need to rest. The Night light setting provides low-level, low-energy light that allows
night routines to go on without disturbing cows. Light is evenly distributed right to the edge of the illumination area
and creates a clearly defined line between the area you want to light and where you don’t. This helps you avoid
over-lighting your barn and reduces the impact of light pollution on the surrounding area.
Take control of your barn
You can’t control when the sun rises and sets – or on which days the sun shines. But you can control
how your barn reacts by 2 Function Selections:
#1 Nature Light Harvest Sensor
2# Auto Lux on and Auto Lux off Function
Note:
Lux-on sampling time–10s；Lux-off sampling time–10s
Thanks for the Dual-PD technology, REAPWAY MPS003 sensor can tell the difference between natural
light and artificial LED light, the sensor will turn on your light fixtures when the ambient light is lower than
the setting value. When the ambient light is up to the setting value, the sensor will switch off the light fixtures.
Application
Dimming function
MPS003 sensor will dynamic dimming your light fixture according to the ambient sunlight lux,
when sunlight is turning up,the light fixture is dimming down,when the sunlight is turning down,
the light fixture is dimming up, this mechanisim to balance the natural ight and the artificial light,
save energy but keep necessary lux level.
